How to adjust the microscope of die laser welding machine?

Mold laser welding machine is a classification of laser welding machine, also known as mold laser repair machine. Its main principle is to use high-capacity laser pulse to carry out laser spot welding of materials, laser repair and other ways to heat the small area, which is a new precision laser welding method. Therefore, the adjustment of the microscope has a great influence on the welding effect. When operating the mold laser machine, how to adjust the microscope to achieve the best effect?

Microscope is very important for mold laser welding machine. If the view is not clear or accurate, it will inevitably affect the welding quality and effect. So how to adjust and use it? The engineers gave their use and adjustment skills.

Fine welding automatic welding equipment engineer: microscope is very important for mold laser welding machine. If the view is not clear or accurate, it will inevitably affect the welding quality and effect. How to use and adjust the microscope of mould laser machine?

1. Before the repair welding operation, turn the clear scheduling knob on the outside of the eyepiece barrel of the microscope clockwise to the end, so that the two eyepiece barrels are at the same height. This is to keep the clarity of the two glasses consistent when observing the workpiece.

2. During operation, put the workpiece on the workbench, move the workbench up and down, and observe the workpiece in the microscope, so that the workpiece is in the clearest state in the field of view of the microscope.

When we repair welding any workpiece, the workpiece should be in a clear state. One is to ensure that the focus height is consistent with the clarity, and the other is that the eye can clearly see the repair welding process, so as to ensure the repair welding quality.

3. During repair welding, the customer is strongly required to observe the workpiece at the same time with two eyes when using the microscope. The eyes should not be close to the eyepiece or far away from the eyepiece, about 5 to 10 mm.

When the field of view can not coincide, the two eyepiece bases of the microscope can be adjusted to keep the distance between the two eyepieces and the distance between the two pupils until the two fields of view coincide. The reason for using two eyes to observe at the same time is that the workpiece we see can be stereoscopic. Can see the high and low position on the workpiece, especially the small position of precision parts can be seen clearly. And the workpiece after repair welding can be inspected to observe whether the repair welding position is undercut or burnt, so as to ensure that the repair welding position and height meet the requirements.