How to maintain the laser cutting machine in Suzhou in summer?

In summer, due to the rising temperature, the air humidity is high. Scientific maintenance of Kunshan jour laser and Suzhou laser cutting machine can prevent many small problems in use

matters needing attention

01. Pay attention to the temperature difference between cooling water and air

Both lasers and optical lenses are cooled by water. Because the water in the air will condense into water when it is cooled, when the cooling water temperature is 5-7 degrees below the room temperature, there will be water condensation on the surface of lasers and optical lenses, which greatly affects the light output efficiency of lasers and the transmission of optical lenses, and has a great impact on the laser energy and the service life of optical accessories. It is suggested that the majority of laser cutting machine users set the water temperature at 30-32 degrees, and control the temperature difference between the cooling water and the room temperature to be greater than 7 degrees

02. Check and maintain the internal pressure of the cooler

When the temperature rises in summer, the working pressure of the cooling system of the laser cutting machine increases. It is recommended to check and maintain the internal pressure of the cooling machine before the high temperature comes. The equipment pressure of different manufacturers is also different. It is recommended to consult the equipment manufacturer for specific parameters before maintenance.

03. Users of laser cutting machine use normal distilled water or pure water

Due to the high temperature in summer, the deterioration rate of cooling water will also be accelerated. It is suggested that users of laser cutting machine should use regular distilled water or pure water, and regularly clean up the scale, so as to avoid causing scale in laser and pipeline and affecting laser power. Different types of laser cutting machine cleaning method is not the same, please operate under the guidance of the equipment manufacturer.

04. Pay attention to the working condition of the cooling fan

As the dust of metal laser cutting machine is mainly metal powder, it is recommended to clean the dust in the gas holder of laser cutting machine regularly and check the working condition of cooling fan.

Scientific and orderly maintenance can effectively avoid some small problems in the use of laser cutting machine, effectively improve the performance and service life of some accessories, and virtually improve the efficiency of work.

The sun in summer, like a big stove, makes the earth hot. Even the air is hot. People sweat when they move.

Attention: be careful of the laser machine frosting. Due to the large difference between the temperature of the water cooler and the ambient temperature, the laser and the cutting head will frosting, which will cause damage to the equipment and lenses. Please increase the temperature of the water cooler. If not, please contact the after-sales service in time to ask how to adjust it.

Remind you again of the temperature setting:

① Summer: low temperature 29, high temperature 30,

② Non summer: low temperature 25, high temperature 30,

For 1500s and 2000s models:

① Summer: low temperature 27, high temperature 30,

② Non summer: low temperature 25, high temperature 30,

Conditional suggest that customers use air-conditioned room: set to 28 degrees dehumidification.

No matter how hard the machine is, it needs to be maintained. Therefore, when the hot summer comes, you should protect your "love machine" and be in the best state all the time to bring you greater benefits.